Lenovo 6446 Instrukcja Użytkownika Pobierz pdf (Strona 52)

supplying adequate DC power to the system. During typical operation, both the ac

and dc power LEDs are lit. For any other combination of LEDs, see the Hardware

Maintenance Manual on the ThinkServer Documentation DVD.

Systems-management Ethernet connector: Use this connector to connect the

server to a network for systems-management information control. This connector is

active only if you have installed a Remote Supervisor Adapter II SlimLine, and it is

used only by the Remote Supervisor Adapter II SlimLine.

Ethernet activity LEDs: When these LEDs are lit, they indicate that the server is

transmitting to or receiving signals from the Ethernet LAN that is connected to the

Ethernet port.

Ethernet link LEDs: When these LEDs are lit, they indicate that there is an active

link connection on the 10BASE-T, 100BASE-TX, or 1000BASE-TX interface for the

Ethernet port.

Ethernet connectors: Use either of these connectors to connect the server to a

network.

USB connectors: Connect a USB device, such as USB mouse, keyboard, or other

USB device, to any of these connectors.

Video connector: Connect a monitor to this connector. The video connectors on

the front and rear of the server can be used simultaneously.

System-error LED: When this LED is lit, it indicates that a system error has

occurred. An LED on the light path diagnostics panel is also lit to help isolate the

error.

System-locator LED: Use this LED to visually locate the server among other

servers.

Power-on LED: When this LED is lit and not flashing, it indicates that the server is

turned on. When this LED is flashing, it indicates that the server is turned off and

still connected to a power source. When this LED is off, it indicates that power is

not present, or the power supply or the LED itself has failed.

Serial connector: Connect a 9-pin serial device to this connector. The serial port is

shared with the baseboard management controller (BMC). The BMC can take

control of the shared serial port to perform text console redirection and to redirect

serial traffic, using Serial over LAN (SOL).

SAS connector: Connect a serial-attached SCSI (SAS) device to this connector.

Server power features

When the server is connected to a power source but is not turned on, the operating

system does not run, and all core logic except for the service processor (the

baseboard management controller or optional Remote Supervisor Adapter II

SlimLine) is shut down; however, the server can respond to requests from the

service processor, such as a remote request to turn on the server. The power-on

LED flashes to indicate that the server is connected to power but is not turned on.

38 ThinkServer RD120 Types 6444, 6445, 6446, and 6447: Installation Guide

1 2 ... 47 48 49 50 51 52 53 54 55 56 57 ... 111 112

Brak uwag

Lenovo 6446 Instrukcja Użytkownika Strona 52