Lenovo THINKSERVER RS210 Instrukcja Użytkownika Pobierz pdf (Strona 183)

The following illustration shows the connectors and LEDs on the rear of the server.

1 Power-cord connector 9 NMI button

2 Serial connector 10 USB 3-4 connector

3 Ethernet 1 activity LED 11 USB 1-2 connector

4 Ethernet 1 link LED 12 Video connector

5 Ethernet 2 activity LED 13 Power supply error LED (amber)

6 Ethernet 2 link LED 14 DC power LED (green)

7 PCI slot 1 15 AC power LED (green)

8 PCI slot 2

You must turn off the server before you connect or disconnect cables.

See the documentation that comes with any external devices for additional cabling instructions. It might

be easier for you to route cables before you connect the devices to the server.

Cable identifiers are printed on the cables that come with the server and optional devices. Use these

identifiers to connect the cables to the correct connectors.

Updating the server configuration

When you start the server for the first time after you add or remove an internal option or external device,

you might receive a message that the configuration has changed. The UEFI Setup Utility program starts

automatically so that you can save the new configuration settings.

Some options have device drivers that you must install. For information about installing device drivers,

see the documentation that comes with each option.

If the server has an optional RAID and you have installed or removed a hard disk drive, see the

documentation that comes with the RAID for information about reconfiguring the disk arrays.

For information about configuring the integrated Gigabit Ethernet controller, see “Configuring the Gigabit

Ethernet controllers” on page 219.

Chapter 6. Replacing FRUs 175

1 2 ... 178 179 180 181 182 183 184 185 186 187 188 ... 243 244

Brak uwag

Lenovo THINKSERVER RS210 Instrukcja Użytkownika Strona 183