Lenovo ThinkServer RD210 Instrukcja Użytkownika Pobierz pdf (Strona 3)

Each slide rail is marked with either an R (right) or

an L (left). Select one of the slide rails and push up

on the front moveable tab 1; then, pull out the

front latch 2 to slide out the front side rail. If a

thumbscrew is installed in the slide rail 3, remove

it.

Note: When you install a 2U server, be sure to

install the slide rails in the bottom U of the 2U area

in the rack.

From the front of the rack, line up the three pins on

the rear of the slide rail with the three holes in the

selected U on the rear of the rack. Push the rails so

that the pins go into the holes 1, and drop the

slide rail down 2 until it latches into place.

Pull the slide rail forward and insert the two pins

1 on the front of the rail into the two lower holes

in the U on the front of the rack. Drop the rail into

place until it clicks. Push the front latch 2 in all

the way.

Repeat steps 1 through 3 to install the other rail

into the rack. Make sure that each front latch is

fully engaged.

Pull the slide rails forward 1 until they click, two

times, into place. Carefully lift the server and tilt it

into position over the slide rails so that the rear nail

heads 2 on the server line up with the rear slots

3 on the slide rails. Slide the server down until

the rear nail heads slip into the two rear slots, and

then slowly lower the front of the server 4 until

the other nail heads slip into the other slots on the

slide rails. Make sure that the front latch 5 slides

over the nail heads.

1 2 3 4 5 6 7

Brak uwag

Lenovo ThinkServer RD210 Instrukcja Użytkownika Strona 3